Noise Floor-The noise at the radio receivers of Radio 1 and Radio 2. ![]() This percentage not only depends on the data bits transferred but also with the transmission overhead that makes use of the channel. The AP uses either the physical or the virtual carrier sense mechanism to sense a busy channel. Utilization-The percentage of time (normalized to 255) that the channels of Radio 1 and Radio 2 are sensed to be busy. Power-The transmit power of Radio 1 and Radio 2 measured in decibels. The AP s table for the Access Points, Up and Down categories displays a list of APs with the following information:Ĭhannel-Channels assigned under Radio 1 and Radio 2. Clicking a specific AP in the table displays the corresponding AP details page. Radios-Displays the total number of active radios.Ĭlicking each of the above component displays the list of APs in respective operational states in the AP list table. ![]() Up-Displays the total number of APs that are up.ĭown-Displays the total number of APs that are down. ![]() To view more details about a specific AP, click the following contents:Īccess Points-Displays the total number of APs. Click the list icon to display the AP list page. SSID is a name given to a WLAN and is used by the client to access a WLAN network. over a specific duration.Ĭlient Count Per Network-Displays the number of clients connected to an AP as per SSID Service Set Identifier. Usage-Displays the incoming and outgoing data traffic to and from the device.Ĭlients Count-Displays the number of clients connected to an AP over a specific time period.īandwidth Usage Per Network-Displays the incoming and outgoing traffic for all APs per SSID Service Set Identifier. Usage-Displays the overall usage metrics for the APs provisioned in your Aruba Central account. The Access Points dashboard includes the following contents: Click Devices > Access Points to view the AP monitoring dashboard.ģ. In the Network Operations app, use the filter bar to select a group.Ģ. To view the Instant AP dashboard perform the following steps:ġ. The APs monitoring dashboard provides all the metrics about the health, status, and clients information associated with the AP provisioned and managed through Aruba Central. ![]() Type: arp -a (look for the MAC address of your access point, and note its IP address) Note: If a secondary AP is not in the ARP list of interfaces, you can also find its assigned IP by logging in to the main NAT router, and looking for it at the LAN wired clients list.You are here: Home > Monitoring Dashboards > Network Overview > Access Points APs Ping your network address (substitute your client IP's last number with. Find the MAC address of your access point (it is usually printed on its label). If the above does not work, or you have multiple access points and you are not connected to the main router, you can try the following solution: 1. In the list, find the line that is your "Default Gateway", this is your primary router/access point. Start > Run > type: cmd (to enter command prompt) 2. If the access point is the main " gateway" NAT router on your network: 1. You can always try doing a factory reset of the ap, and connect to its default IP address (with its factory username/password), but then you have to reconfigure it to work with your network. The IP address may, or may not show in the DHCP client list on your main router/gateway. You need the AP IP to be able to connect and reconfigure it. Sometimes you can have a wireless access point on your network that you do not know the IP address of.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |